Device Configuration

Introduction

This section is not a tutorial on configuration different manufacturers. Here you will find the minimum settings in the CLI (for access from MUPSBOX to devices).

Vendor Configuration

Cisco - IOS v15

Minimum configuration:

BASIC CONFIG - SUMMARY STEPS

1. enable

2. configure terminal

BASIC CONFIG - DETAILED STEPS
	Comman or Action	Purpose
Step 1	enable Example: Router> enable	Enables privileged EXEC mode. Enter your password if prompted.
Step 2	configure terminal Example: Router# configure terminal	Enters global configuration mode.
Step 3	interface gigabitethernet slot/port Example: Router(config)# interface gigabitethernet 0/0	Specify the port adapter type and the location of the interface to be configured.
Step 4	ip address ip subnetmask Example: Router(config-if)# ip address 10.9.90.201 255.255.255.0
Step 5	no shutdown Example: Router(config-if)# no shutdown
Step 6	exit Example: Router(config-if)# exit
Step 7	ip route 0.0.0.0 0.0.0.0 gateway Example: Router(config)# ip route 0.0.0.0 0.0.0.0 10.9.90.1
Step 8	ip domain name domain name Example: Router(config)# ip domain name domain.local
Step 9	hostname newhostname Example: Router(config)# hostname MBRouter
Step 10

BASIC CONFIG - DETAILED STEPS
	Comman or Action	Purpose
Step 1	enable Example: Router> enable	Enables privileged EXEC mode. Enter your password if prompted.
Step 2	configure terminal Example: Router# configure terminal	Enters global configuration mode.
Step 3	interface gigabitethernet slot/port Example: Router(config)# interface gigabitethernet 0/0	Specify the port adapter type and the location of the interface to be configured.
Step 4	ip address ip subnetmask Example: Router(config-if)# ip address 10.9.90.201 255.255.255.0
Step 5	no shutdown Example: Router(config-if)# no shutdown
Step 6	exit Example: Router(config-if)# exit
Step 7	ip route 0.0.0.0 0.0.0.0 gateway Example: Router(config)# ip route 0.0.0.0 0.0.0.0 10.9.90.1
Step 8	ip domain name domain name Example: Router(config)# ip domain name domain.local
Step 9	hostname newhostname Example: Router(config)# hostname MBRouter
Step 10

MupsBox will sort the data and display only the values found. These data can be exported to Excel for further processing.

Cisco - IOS L2 v15

To search for data by given dates and times, check the boxes next to them and select the date and time you are interested in:

Cisco - IOS L2 v12

To filter by prefix, click the down arrow in the prefix field, as shown in the figure below and select the prefix or prefixes by which you need to filter the data.