Difference between revisions of "MTMS (MikroTik Mobile Survey)"

From Mupssoft Wiki
Jump to navigation Jump to search
Line 39: Line 39:
 
</ul>
 
</ul>
 
|}
 
|}
 +
<p>Below you can update once, put the calculation in 5 or 10 seconds, or put automatic data update. You can also save this data. In the top Name the object and selecting points from A to P and from 1 to 17 you can save the data.</p>

Revision as of 01:10, 4 July 2019

About MTMS

Survey covering the wireless AP on ROS , Single AP, CapsMan, Roaming between CAP, save result for plan and analyzing results.

How to install

To install the program on the android, go to the PlayMarket and in the search box type MTMS.


Login in MTMS

MTMS
  • Connect to - Enter the IP address of the Wi-Fi access point or СapsMan.
  • Login - Login to RouterOS
  • Password- Password to login to device.
  • pre 6.43 - If the RouterOS version is lower than 6.43
  • Save Conf - Saves entered data
  • Connect - connect to AP or CapsMan
  • Disconnect - disconnect from AP or CapsMan

Survey

Only works with access point

MTMS Client Side:
  • SSID - what SSID client is connected to
  • BSID - MAC address of the interface on the AP to which the client is connected
  • MacAddress - Mac address of the client
  • IPAddress -
  • LinkSpeed - Tx Rate
  • RSSI - TX Signal Strength (dBm)

AP Side:

  • AP Conf - AP configuration for this SSID
  • Client MAC - Mac address of the client
  • Client IP - IP address of the client
  • RX/TX Rate - RX/TX Rate
  • CCQ/SNR - CCQ and SNR
  • RSSI - RX Signal Strength (dBm)

Below you can update once, put the calculation in 5 or 10 seconds, or put automatic data update. You can also save this data. In the top Name the object and selecting points from A to P and from 1 to 17 you can save the data.